In the production process of outdoor LED displays, to ensure their waterproof performance, multiple aspects need to be considered. First, the PCB board should undergo anti-corrosion treatment, such as coating with a conformal protective layer. High-quality power supplies and power cables should be selected, and the enclosure must have good sealing, with the display meeting the IP65 standard. Solder joints are prone to corrosion and require special protection, especially the frame, which should be treated for rust prevention. For unit boards made of different materials, professional waterproof coatings should be used. Additionally, the design of waterproof grooves in the unit board kits is very important. Waterproofing of the back panel should not be overlooked, as the back panel not only serves the function of heat dissipation but also needs to ensure waterproof performance. When applying waterproof coatings on the back, drainage holes should be designed under the aluminum-plastic panel to facilitate both waterproofing and heat dissipation.
During on-site installation, both waterproofing and drainage methods need to be considered. In terms of structural design, sealing strip materials with good performance should be selected, such as hollow tube structures with low permanent compression deformation and high elongation before breaking. After selecting the sealing strip material, it is necessary to design appropriate contact surfaces and force distribution according to its characteristics, so that the sealing strip reaches a dense state and ensures waterproof effectiveness.
In daily use, the waterproofing of outdoor LED displays also requires attention. While in operation, the display generates heat, which helps evaporate water vapor and reduces the risk of short circuits caused by humidity. It is recommended that during the rainy season, the LED display be used at least once a week, with a lighting time of more than 2 hours, to maintain its normal operation and waterproof performance.