Set the output resolution of the LED screen

Apr 02, 2026

Leave a message

Set the output resolution of the LED screen

To set the output resolution of the LED screen, multiple steps including system, player, graphics card and control software need to be coordinated and adjusted. The specific steps are as follows: 

Adjust the base resolution

Right-click on the desktop and select "Screen Resolution Settings". Set the resolution of the main display to the parameter that matches the physical resolution of the LED screen (e.g. 1920×1080). If the modification does not take effect directly, enter the "Advanced Display Settings" and configure the parameters for the corresponding display of the LED screen separately. Some systems require manually selecting the appropriate resolution mode in the "Display Adapter Properties". 

2. Configure display parameters separately

In the "Advanced Display Settings", select the display corresponding to the LED large screen, and modify its desktop resolution and signal resolution. For example, set the signal resolution to 1920×1080 and the refresh rate to 59Hz (adjust according to the device's support). Through the "List All Modes" option, select the combination that exactly matches the physical resolution of the LED large screen to avoid display abnormalities caused by incompatible resolutions. 

3. Check the output resolution of the player

If using a professional player (such as vmix, P1 trial version), make sure that the output resolution of the player is consistent with the optimal resolution of the LED screen. For example, a 2K output should correspond to the parameters of 1920×1080. Also, check whether the input and output resolutions on the processor side are matched to avoid resolution loss due to signal conversion. 

4. Graphics Card Driver and Mode Optimization

Install the latest graphics card driver (such as the official drivers from NVIDIA or AMD), to avoid display abnormalities caused by driver issues. When playing PPT or other content, switch the display mode by pressing the Windows key + P key (the "Extended Mode" is recommended), and adjust the PPT playback ratio to match the computer desktop resolution (for example, a 16:9 widescreen ratio corresponds to 1920×1080). 

5. Control of software parameters

Using the LED display control software (such as NovaLCT, Ledset), select the parameters in the "Display Settings" that exactly match the physical resolution of the LED screen (for example, a point spacing of P2.5 corresponds to 1920×1080). Calibrate the display area to ensure that the content is displayed completely without distortion. Some software requires setting the "Zoom Ratio" to 100% to avoid automatic stretching that causes resolution errors. 

Notes:

 

Before making adjustments, back up the current resolution settings to prevent black screen due to accidental operation.

If the LED screen supports multiple resolutions, choose its original physical resolution to achieve the best display effect.

The parameter names of the control software for different brands of LED screens may vary. Please refer to the device manual.

Send Inquiry