To change the connection between the LED display's sending and receiving cards from a 568B Ethernet cable to a wireless connection, the following solutions can be considered, but limitations related to data volume and screen size must be considered:
Assess screen size and data volume:
Full-color LED displays: Due to the large data volume, wireless connections may be unstable or unable to meet transmission requirements. Therefore, switching to wireless connections is not recommended for large full-color screens.
Small screens or monochrome/dual-color screens: If the screen is small and the amount of data displayed is not large, a wireless connection can be considered.
Using a wireless router:
Connecting the sending card: Set up a wireless router near the sending card, ensuring the sending card can connect to the router via wired or wireless means.
Signal transmission: Configure the router to receive signals from the computer and wirelessly transmit these signals to devices near the receiving card.
Receiver setup: Set up a wireless receiving module near the receiving card. This module needs to be able to receive signals from the router and convert them into signals that the receiving card can recognize.
Computer Configuration and Signal Transmission:
IP Address Configuration: Ensure the computer, router, and receiving device are all on the same local area network (LAN) and configured with the correct IP addresses.
Signal Transmission: Configure the LED display playback software on the computer to send the displayed content to the router via the LAN, and then the router wirelessly transmits it to the receiving device.
Precautions:
Stability: The stability of the wireless connection may be affected by environmental factors such as obstacles and interference sources. Therefore, in practical applications, it is necessary to ensure the stability and reliability of the wireless connection.
Latency: Wireless connections may introduce a certain amount of latency, which should be carefully considered for applications with high real-time requirements.
Security: Ensure the security of the wireless connection to prevent data leakage or unauthorized access.
In summary, changing the connection between the LED display's transmitting and receiving cards to a wireless connection requires comprehensive consideration of factors such as screen size, data volume, stability, latency, and security. If conditions permit and the requirements are reasonable, a wireless router and wireless receiving module can be considered to achieve this function.