What are the waterproofing, moisture-proofing, and remedial measures for outdoor LED displays?

Apr 05, 2026

Leave a message

 

The waterproofing, moisture-proofing, and remedial measures for outdoor LED displays are as follows: Waterproofing and Moisture-proofing Measures
Production Process
PCB Board Treatment: During the production of LED displays, the PCB board must undergo anti-corrosion treatment, such as applying a conformal coating.

Accessory Selection: High-quality power supplies and power cables should be used.

Cabinet Sealing: A waterproof cabinet with good sealing should be used, and the screen must meet an IP65 protection rating.

Soldering Joint Protection: Welding joints are the most susceptible to corrosion, so proper protection is essential.

Frame Treatment: The frame is prone to rust, so rust prevention treatment is necessary.

Unit Board Treatment: Different unit board materials require professional waterproof coatings; check if the unit board kit has waterproof grooves.

Back Panel Waterproofing: Pay attention to the waterproofing of the back panel of outdoor LED displays. When applying a waterproof coating to the back, use a drill to design a row of drainage holes under the aluminum composite panel. This facilitates both waterproofing and heat dissipation for the display.

On-site Installation and Construction

Combined Prevention and Drainage: The structural design combines prevention and drainage. After the structure is determined, based on its characteristics, sealing strip materials with properties such as hollow bubble tube structure, low compression set, and high elongation at break can be considered. After selecting the sealing strip material, appropriate contact surfaces and contact forces need to be designed according to its characteristics to ensure the sealing strip is compressed into a dense state.

Key Protection: Key protection should be applied to installation areas, waterproof channels, etc., to ensure that no water accumulates inside the display screen.

Daily Use
Frequent Use: Outdoor screens need frequent use because the display screen itself generates heat during operation, which can evaporate some water vapor, greatly reducing the possibility of short circuits caused by moisture. During the rainy season, the LED screen should be used at least once a week and turned on for at least 2 hours per month.

Water Ingress Remedial Measures
Screen Drying: Use a fan or other tools as quickly as possible to completely dry the water-damaged LED display screen.

Power-on Aging: After the screen is completely dried, power it on for aging. The specific operating methods are as follows:

Adjust brightness (full white) to 10% and power-on for 8-12 hours.

Adjust brightness (full white) to 30% and power-on for 12 hours.

Adjust brightness (full white) to 60% and power-on for 12-24 hours.

Adjust brightness (full white) to 100% and power-on for 8-12 hours.

Precautions:

Do not put water-damaged LED screens into flight cases, as this can easily damage the LEDs.

If the warehouse is flooded, the flight cases may also get wet. All flight cases must be exposed to direct sunlight to prevent moisture from evaporating into the LED display after packing.

If water-damaged LED displays are not treated promptly, it may affect the stability of the screen. During emergency treatment, the screen may experience continuous LED failures after being powered on.

Screens that have been in flight cases for more than 3 days after water damage are essentially beyond repair. These screens should be handled with caution.

Send Inquiry