In recent years, LCD panel assembly has emerged as a new type of assembly technology following DLP and PDP assembly. LCD panel assembly walls have the advantages of low power consumption, light weight, long lifespan (generally capable of operating for 50,000 hours), no radiation, and uniform picture brightness. However, its biggest drawback is that it cannot achieve seamless assembly. For industry users who require extremely fine display pictures, this is somewhat of a disappointment. Due to the presence of a frame on the LCD screen when it is manufactured, assembly will result in a frame (gap). For example, the frame of a single 21-inch LCD screen is generally 6-10mm, and the gap when two LCD screens are assembled is 12-20mm. Currently, there are several approaches in the industry. One is narrow-gap assembly, and the other is micro-gap assembly. Micro-gap assembly means that the manufacturer removes the casing of the purchased LCD screen and connects the glass to the glass, but this approach has a higher risk. If the LCD screen is not disassembled properly, it may damage the overall quality of the LCD screen. Currently, only a few manufacturers in the industry use this method. Due to the problem of LCD screen and LCD assembly gap, it has become a bottleneck in development. From the initial 22mm gap to the current 7.3mm ultra-narrow edge, and then to this year's new 5.5mm "seamless", the size of the gap has been constantly updated. This is the main reason for the rapid development of LCD displays. With the development of technology, the gap will continue to shrink to a narrower size, and achieving a 3mm gap is not an impossible dream. As for the large-screen assembly market, LCD screens and rear-projection screens are the two major assemblies that attract attention. It is necessary to mention the development trend of LCD screens. In just a few years, it has formed a market strength that is 20 times that of DLP rear-projection, and the development speed is truly astonishing!