How to change the receiver card interface in LEDVision?

Mar 29, 2026

Leave a message

The general steps for replacing the receiver card interface in LEDVISION include backing up the configuration, powering off and removing the card, installing the new card, reconnecting, configuring parameters, and comprehensive debugging.

The specific steps are as follows:

Backing up configuration information:

Before replacing the receiver card, if possible, ensure that all configuration information on the original receiver card has been backed up. This helps to quickly restore the display settings after the replacement.

Powering off and disconnecting cables:

Turn off the display power, ensuring safety.

Disconnect all cables connected to the receiver card, including data cables, power cables, etc.

Removing the original receiver card:

Carefully remove the original receiver card from the display. Be careful not to damage other parts of the display or surrounding circuitry.

Installing the new receiver card:

Install the new receiver card onto the display, ensuring it is securely connected to the rest of the display.

Reconnect all previously disconnected cables, ensuring the connections are correct and secure.

Powering on the display and configuring parameters:

Power on the display.

Start the LEDVISION broadcast control software.

Reconfigure the receiver card's parameters in the software, such as communication parameters (IP address, baud rate, etc.), physical dimensions, and scanning method. These parameters need to be set according to the specifications of the new receiver card and the display's requirements.

Comprehensive Testing:

After completing the configuration, perform comprehensive testing. This includes checking whether the display's display effect, brightness, color temperature, and other parameters meet the requirements.

If any problems are found, adjust and repair them promptly to ensure the display functions properly.

Please note that the above steps are for reference only and may vary depending on the specific display model, receiver card brand, and software version. Before performing any operations, please refer to the relevant user manual or contact technical support for accurate guidance.

Send Inquiry